Rice Lake TS Series, Rice Lake Weighing Systems - Operation Manual - Manual (Page 70)

66 RL-TS Series Operation Manual
5
Perform span adjustment or span test. After span adjustment or test is successfully
completed, the printer executes printing.
While the data is being printed, the balance may
seem to not be moving, but wait until printing is
completed.
No printing is executed if span adjustment or
test is not successfully completed.
Do not press any keys on the printer during
printing.
Printing measurement results
1
Set to the function setting mode.
(Refer to “Section 2-5: Function Setting
Basics (P.
X
22
X
).)
Press and hold the [Function] key. After “Func” is displayed,
release the finger.
2
Press the [Function] key several times to select “E.GLP.”
Select “1” by pressing the [Zero/Tare] key.
3
Press the [Function] key several times to select “E2.od.”
Select “1” by pressing the [Zero/Tare] key.
4
Save the setting. Press the [Target] key.
The balance goes back to normal display.
5
Print. Pressing and holding the [Print] key prints the header.
- Pressing the [Print] key at any time during measurements
prints result data.
- After the measurement is completed, press and hold the
[Print] key. The footer is printed.
Do not press any keys on the printer during printing.