Altera ALTDLL - Manual (Page 76)

Chapter 4: Functional Description 4–40
ALTDQ_DQS Megafunction Ports
© February 2012 Altera Corporation ALTDLL and ALTDQ_DQS Megafunctions User Guide
DQ Output Path Megafunction Ports
Table 4–16 summarizes all the ports on the megafunction that configure the DQ
Output path. The possible values for <IO> are BIDIR_DQ and OUTPUT_DQ .
Table 4–16. Megafunction Ports to Configure DQ Output Path (Part 1 of 2)
Port Name Type
Optional/
Required Default Description
bidir_dq_areset
[n
b
-1..0]
Input Optional GND This port is connected to all areset ports in the
bidirectional DQ IO primitives that is used to
asynchronously reset the registers in those
primitives.
bidir_dq_hr_output_dat
a_in[4*n
b
-1..0]
Input Optional GND This port feeds the half-rate DDR bidirectional DQ
signal for the
BIDIR_DQ_OUTPUT_HR_DDIO_OUT_HIGH:
datainhi / datainlo and
BIDIR_DQ_OUTPUT_HR_DDIO_OUT_LOW:d
atainhi / datainlo ports.
bidir_dq_output_data_i
n [n
b
-1..0]
Input Optional GND This port feeds the bidirectional DQ signal for the
BIDIR_DQ_OUTPUT_FF:d ,
BIDIR_DQ_OUTPUT_DELAY_CHAIN1:data
in ,
BIDIR_DQ_OUTPUT_DELAY_CHAIN2:data
in , or bidir_dq_output_data_out port
bidir_dq_output_data_i
n_high[n
b
-1..0]
Input Optional GND This port feeds the full-rate DDR bidirectional DQ
signal (rising edge) for the
BIDIR_DQ_OUTPUT_DDIO_OUT:datainhi
port.
bidir_dq_output_data_i
n_low[n
b
-1..0]
Input Optional GND This port feeds the full-rate DDR bidirectional DQ
signal (falling edge) for the
BIDIR_DQ_OUTPUT_DDIO_OUT:datainlo
port.
bidir_dq_output_data_
out[n
b
-1..0]
Output Optional — This port outputs the bidirectional DQ signal from
the
BIDIR_DQ_OUTPUT_DELAY_CHAIN2:data
out ,
BIDIR_DQ_OUTPUT_DELAY_CHAIN1:data
out , BIDIR_DQ_OUTPUT_FF:q ,
BIDIR_DQ_OUTPUT_DDIO_OUT:dataout ,
or bidir_dq_output_data_in port.
bidir_dq_sreset
[n
b
-1..0]
Input Optional GND This port is connected to all sreset port in the
bidirectional DQ IO primitives that is used to
synchronously reset the registers in those
primitives.
dq_hr_output_reg_clk Input Optional GND This port feeds the output enable signal for the
<IO>
_OUTPUT_FF:ena and
<IO> _OUTPUT_DDIO_OUT:ena ports.
dq_output_reg_clk Input Optional GND This port feeds the clock signal for the
<IO>
_OUTPUT_FF:clk and
<IO> _OUTPUT_DDIO_OUT:clkhi / clklo /
muxsel ports.