BINDER KBF LQC 240 - Manual (Page 43)

KBF LQC (E5.3) 07/2014 page 43/114
8. Manual Mode
In Manual Mode (HAND) you can enter a temperature set-point, a humidity set-point, the fan speed (0%
to 100%), and the target dose values of UVA and visible spectral range can be entered. You can enter
the switching-state of up to 8 operation lines (non-functional with standard unit). All settings remain valid
for Manual Mode (HAND) until the next manual change, also if the unit had been turned off or in case of
toggling to Idle Mode or Program Mode (AUTO).
8.1 Entering the set point values
TEMP
20.0 22.1
°C
HUMID 30.0 21.7 %rH
VIS
0.0 0.0
UVA 0.0 0.0
LIGHT INTEGR. OFF
HAND
08:43:55 15.12.13
Idle Mode
No heating or refrigerating function,
no humidification.
Fan working at 50% rate (factory
setting).
Illumination ON or OFF according to
the position of the manual switch.
Toggling to Manual Mode
Change of page
Toggling between temperature set-point, humidity set-point, target value for VIS integration in MLUXh,
target value for UVA integration in Wh/m 2 , and fan speed.
Arrow buttons to select the operation
lines (no function)
Arrow buttons to
enter the value
Button to move the decimal point
08:43:55 15.12.13
HAND
08:43:55 15.12.13
Operating contacts
Contact 1
Contact 2
Contact 3
Contact 4
Contact 5
Contact 6
Contact 7
Contact 8
On
Off
Aus
Aus
Aus
Aus
Aus
Off
HAND
Contact 1
Off
On
Hand-Mode
TEMP +40.0 °C
HUMID
DOSE MLUXh
DOSE Wh/m2
FAN SPEED
Operating contacts +65.0 %r.H.
EXIT
+80.0 %
TEMP
+0060.0 °C
08:43:55 15.03.13
HAND
HAND
Hand-Mode
TEMP
SPEED
+29.3 °C
+80.0 %
Hand-Mode
TEMP +40.0 °C
+50.0 %
PGM CONFIG W VIEW->
EXIT
HUMID
DOSE MLUXh
DOSE Wh/m2
FAN SPEED
Operating contacts +65.0 %r.H.