A.4 hpi_shell utility – Artesyn System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User's Guide (June 2014) User Manual
Page 127
Example Applications
System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User’s Guide (6806800P20C)
127
DAEMON-HA-PROTOCOL
A.4
hpi_shell Utility
The hpi_shell utility is contained in /opt/bladeservices/bin directory. The usage of
hpi_shell
with sample output is shown below. At any stage, type help for getting
information about the hpi_shell usage.
-bash-3.00$ hpi_shell
Discovery done
Enter a command or "help" for list of commands
Available commands are:
addcfg ann clearevtlog ctrl
dat debug dimi domain
domaininfo dscv echo event
evtlogtime evtlogreset evtlogstate exec
fumi help history hs
inv lsres lsensor more
parmctrl power quit rdr
reopen reset rpt run
sen settag setsever settimeevtlog
On ATCA-MF106 and SAM1411 shelf managers, do not use the hpirestartdaemon sample
application to restart the HPI-B daemon. Start/Stop the daemon as mentioned in
. The supervisor does not allow to restart the HPI-B daemon fourth
time if it happened be stopped with hpirestartdaemon sample application. After three
restarts of the HPI-B daemon, supervisor thinks that there is a problem with the HPI-B
daemon, and stops spawning it.