Artesyn System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User's Guide (June 2014) - Manual (Page 87)

Using HPI-B
System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User’s Guide (6806800P20C) 87
4.7 Serial Over LAN Configuration
The ATCA-MF106 and SAM-1411 has the capability to automatically configure the Serial Over
LAN (SOL) feature as specified for IPMI V2.0. The SOL feature, for example, allows you to view
the boot process and the BIOS settings of a blade and to change BIOS settings if necessary.
Whenever a front blade is discovered in the shelf, the ATCA-MF106/SAM-1411 checks whether
the blade supports SOL. If it does support SOL, the ATCA-MF106/SAM-1411 performs all
configuration steps necessary to use the SOL feature.
This includes the following:
1. Configure an IPMI user
2. Configure user privileges
3. Configure LAN channel parameters
4. Configure SOL parameters
The most significant parameters to configure are the IP addresses of the LAN channels. These
are calculated according to the following formula:
LAN channel IP address = <shelf IP address> +<LAN channel> * <configurable multiplier> +
0.0.0.<10*logical slot> + <configurable offset>
TypeUnion.Analog.Default Default blower speed level
DefaultMode.Mode SAHPI_CTRL_MODE_AUTO
DefaultMode.ReadOnly SAHPI_TRUE
WriteOnly SAHPI_FALSE
Table 4-51 Fan Resource - Control State
SaHpiCtrlStateT Value
Type SAHPI_CTRL_TYPE_ANALOG
StateUnion.Analog Current blower speed level
Table 4-50 Fan Resource - Control (continued)
SaHPICtrlRecT Value