Artesyn System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User's Guide (June 2014) - Manual (Page 53)

Using HPI-B
System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User’s Guide (6806800P20C) 53
After calling saHpiControlStateSet(), a new resource with the domain name you
supplied as parameter is created. Additionally, a hot swap event of type ACTIVE for the created
resource is sent. The newly created shelf is also added to the HPI multishelf configuration file as
a new entry.
4.4.5.2 Removing Shelves and Domains
In order to dynamically remove a shelf/domain, you must invoke the HPI function
saHpiControlStateSet()
and provide the following parameters.
CtrlState
Pointer to control state as described in Table
"Domain Management Control State" on page 48 .
In this control state, fill the field body as follows:,
[0] : 1
(stands for "create domain")
[1] - [4]
: IP address of shelf you want to add
(little endian order)
[5] - [6]
: port of shelf (little endian order)
[7] - [n]
: Domain name
Parameter Value
All shelves must have different IP addresses.
Parameter Value
SessionId
Handle to session context.
ResourceId
Resource ID of the addressed resource.
CtrlNum
Number of the control for which the state is being
set.