Artesyn System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User's Guide (June 2014) - Manual (Page 28)

Software Installation and Configuration
System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User’s Guide (6806800P20C) 28
2.3 Setting Up HPI Clients
This section describes how to install/configure HPI clients on node blades.
2.3.1 Installing HPI Clients
Procedure
In order to install an HPI-B client package on a node blade, proceed as follows.
1. Connect to the node blade where you wish to install the HPI-B package.
2. Copy the RPM file that you wish to install to the node blade. Refer to Table "RPM
Files for HPI-B Clients" on page 19 for details on available RPM files for your
particular node blade.
HPI_OEM_DISCRETE_SENSOR_D
EF_SEVERITY
HPI-B Daemon will set
the severity for the
HPI events of non-
threshold sensors
based on the value
configured for this
tag.
Note: If this tag is set
to 3, then change the
OPENHPI_LOG_ON_
SEV
tag to
"INFORMATIONAL"
instead of "MINOR"
so that it logs events
of
"INFORMATIONAL"
severity also into DEL.
<0,1,2,3> [3]
- informational
0
- critical
1
- major
2
- minor
Commented by default,
Please uncomment in the config file
for the tag to take effect.
0
- critical
daemon will assign the
default "critical" severity
for the events of non-
threshold
sensors(discrete/OEM)
SOL and cooling related options are not described in this table. For more information on this,
refer to
Cooling Management on page 77 and Serial Over LAN Configuration on page 87 .
Table 2-4 Plugin Specific Parameters (continued)
Tag Description Allowed values Default in Config. file Built-in Default