Artesyn System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User's Guide (June 2014) - Manual (Page 67)

Using HPI-B
System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User’s Guide (6806800P20C) 67
4.5.8 HPI Daemon Switchover Control
This HPI control handles the switchover between the active and deactivated HPI-B daemon.
The location (active/deactivated) of the HBI daemon cannot be controlled directly. Instead,
this HPI control can be used to initiate a switchover. After the switchover is completed, if
eventing is enabled for the active HPI-B daemon sensor, the HPI Implementation will send an
event with the Resource Id of the new Resource hosting the active HBP daemon.
RdrTypeUnion.SensorRec.Thresh
oldDefn.ReadThold,
RdrTypeUnion.SensorRec.Thresh
oldDefn.WriteThold,
RdrTypeUnion.SensorRec.Thresh
oldDefn.Nonlinear
These values are not meaningful,
because the IsAccessible flag is set
to SAHPI_FALSE.
RdrTypeUnion.SensorRec.OEM
Assigned by HPI implementation
IdString MOTHPI_SENSOR_ACTIVE_DAEM
ON_NAME
MOTHPI_SENSOR_STANDBY_DAE
MON_NAME
.
Table 4-25 Active and Stand-By HPI Daemon Sensors Reading
SaHpiSensorReadingT Value
isSupported SAHPI_TRUE
Type SAHPI_SENSOR_READING_TYPE_UINT64
Value
ResourceId in least significant 32 bits if one is present,
otherwise SAHPI_UNSPECIFIED_RESOURCE_ID
Table 4-26 Active and Stand-By HPI Daemon Sensors Event State
SaHpiEventStateT Value
EventState SAHPI_ES_PRESENT | SAHPI_ES_ABSENT
Table 4-24 Active and Stand-By HPI Daemon Sensors RDRs (continued)
SaHpiRdrT Value Notes