Artesyn System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User's Guide (June 2014) - Manual (Page 21)

Software Installation and Configuration
System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User’s Guide (6806800P20C) 21
OPENHPI_DEL_SAVE
sets whether the domain
event log will be persisted to
disk or not. The event log is
written to
OPENHPI_VARPATH
value
"YES | NO" [NO]
- not saved
[YES] - saved to
OPENHPI_VARPATH
NO
OPENHPI_DAT_SIZE_LIMIT
Sets the maximum size for
the alarm table
<0…N> [1000]
- max size is 1000
0 - unlimited
1000
OPENHPI_DAT_USER_LIMIT
sets the maximum number
of user type alarm entries
allowed in the alarm table
<0…N> [100]
- max size is 100
100
OPENHPI_LOG_ON_SEV
sets the lowest severity level
an event must meet to be
logged in the domain event
log
(Order:
Highest to
Lowest)
"CRITICAL
|
MAJOR |
MINOR |
INFORMATIO
NAL| OK |
DEBUG"
[INFORMATIONAL]
– all
events with INFORMATIONAL
and above severity are
logged
CRITICAL | MAJOR |
MINOR |OK | DEBUG
–
Events with given severity and
above that are logged.
INFORMATI
ONAL
OPENHPI_AUTO_INSERT_TIMEOUT
Sets the default auto-insert
timeout. If the resource is
not shelf manager auto
activated, it starts an auto
insert timer, otherwise the
resource stays in insertion
state until user explicitly
issues
saHpiResourceActiveSet
API. (This information is
taken from PICMG Fru
Activation and Power
Descriptor record)
"block |
<0…N>"
[block]
- auto insertion
policy never executed until user
issues
saHpiResourceActiveSet
()
<0…N>
Any positive value
would give timeout in
nanoseconds.
block
OPENHPI_AUTO_EXTRACT_TIMEOUT
Sets the default autoextract
timeout. If the resource is
not shelf manager auto
deactivated, it starts an auto
extract timer otherwise the
resource stays in extraction
state until user explicitly
issues
saHpiResourceInactiveSet
API (This information is
taken from PICMG Fru
Activation and Power
Descriptor record)
"block |
<0…N>"
[60000000000]
- 60000
milli-seconds block - auto
extraction policy never
executed until user issues
saHpiResourceInactiveSet()
block
OPENHPI_PATH
Search path for plugins Any valid
search path
[/opt/bladeservices/li
b/bbs-hpib] /opt/blad
eservices
/lib/bbs-
hpib
Table 2-3 HPI Tags (continued)
Tag Description Allowed values Default in Config. file
Built-in
Default