Mathey Dearman CNC Saddle Machine - Manual (Page 67)

CNC Saddle Machine Parts & Operating Manual 03-0117-MSA 03-0117-1SA 03-0117-2SA Ver 1.0
67
Figure 6-22 Wait Time between Cuts Screen
3. Wait Time Numeric – Clicking (3) will bring the number of seconds up or down. When done, click
the save/apply button (4). This value will only be used if the ‘Full Cut Automation’ (1) option is
checked.
4. Save/Apply Button – When clicked this will save the value in the ‘Wait Time Numeric’ (3). This
value will be saved MatheyCNC software wide and will only reset whenever it is saved over.
5. Sequential Cut Viewport – This viewport is structured the same as the normal viewport except it
will show all of the cuts contained in this sequential cut. The cut highlighted in red is the cut that is
the currently selected cut. This is changed by selecting a different value from the list of cuts (7).
6. Currently Cutting Label – Displays the configured cut currently being executed or, if the cut has not
been started, it shows what cut will be executed next.
a. Below are examples of the different messages that may appear:
1. Before the cut
2. When the machine is moving to the first position
3. Cutting
4. Paused
5. Stopped
7. Cut List Box – Displays all the separate cuts that are a part of the sequential cut. The cut highlighted
in yellow is the currently selected cut. This cut is displayed as a red line in the viewport (5).
8. Sequential Cut Information Box – This shows the same cut information displayed in the lower cut
information box except this information only pertains to the selected cut from the cut list box (7).
The cut information for the entire sequential cut is located in the normal cut information box.