Mathey Dearman CNC Saddle Machine - Manual (Page 97)

CNC Saddle Machine Parts & Operating Manual 03-0117-MSA 03-0117-1SA 03-0117-2SA Ver 1.0
97
6.7.13 Square Offset (Square Hole Only) (Figure 6-56)
Figure 6-56 Square Offset (Square Hole Only) Screen
1. Square Offset Up Button – Increases the overall length and width of the square cut by one increment.
The maximum is defined by an internal value.
2. Square Offset Value – Amount to increase the overall length and width of the square cut in inches. This
is useful when inserting a square pipe into the square hole, slag and other bits of cut pipe will restrict the
size of the opening. This value is similar to ‘Saddle Hole Kerf Outward Offset’ (Figure 6-11 – [10]).
3. Square Width Down Button –Decreases the overall length and width of the square cut by one
increment. The minimum value is zero.
4. Back Button – Go to the previous cut selection screen.
5. Next Button – Go to the next cut selection screen.