RLE FMS8 User Manual
Page 34
Falcon User Guide
34
EIA-485
The
EIA-485
link is used to create polling addresses
for Falcon units wired in series on the EIA-485 bus,
as well as the communications baud rate for the bus.
Before entering addresses, be sure each unit’s SW2
is set properly. Each poll address must be a unique
number from 2 through 254. They are entered
sequentially, separated by commas.
9600 is the default baud rate setting.
Alarm Dial Out
specifies which of the
pre-programmed phone numbers to dial if a
communications loss occurs, and in which sequence
to call them.
Press the
Submit Changes
button when done to
save all schedule changes.
Clock
The
Clock
link allows users to set the date and time
on the Falcon’s internal clock.
Press the
Submit Changes
button when done to
save all schedule changes.