H3C Technologies H3C S6300 Series Switches - Manual (Page 147)

134
Some operation parameters for an NQA template can be specified by the template configuration or the
feature that uses the template. When both are specified, the parameters in the template configuration
take effect.
Configuring the ICMP template
A feature that uses the ICMP template creates and starts the ICMP operation to measure the reachability
of a destination device. The ICMP template is supported in both IPv4 and IPv6 networks.
To configure the ICMP template:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create an ICMP template and
enter its view.
nqa template icmp name N/A
3. (Optional.) Specify the
destination IPv4 or IPv6
address of the operation.
• IPv4 address:
destination ip ip-address
• IPv6 address:
destination ipv6
ipv6-address
By default, no destination IP address
is configured.
4. (Optional.) Specify the
payload size for each ICMP
request.
data-size size The default setting is 100 bytes.
5. (Optional.) Specify the
payload fill string for requests. data-fill string
The default setting is the hexadecimal
number
00010203040506070809.
6. (Optional.) Specify the IP
address of the specified
interface as the source IP
address of ICMP echo
requests.
source interface interface-type
interface-number
By default, no source IP address is
specified. The requests use the
primary IP address of the outgoing
interface as their source IP address.
If you configure both source ip and
source interface, the most recent
configuration takes effect.
The specified source interface must
be up. The source IP address must be
the IP address of a local interface
and the interface must be up.
7. (Optional.) Specify the source
IPv4 or IPv6 address for the
probe packets.
• IPv4 address:
source ip ip-address
• IPv6 address:
source ipv6 ipv6-address
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
probe packets can be sent out.
Configuring the DNS template
A feature that uses the DNS template creates and starts the DNS operation to determine the status of the
server. It is supported in both IPv4 and IPv6 networks.