H3C Technologies H3C S6300 Series Switches - Manual (Page 185)

172
Step Command Remarks
2. Configure the remote probe
VLAN for the specified remote
destination group.
mirroring-group group-id
remote-probe vlan vlan-id
By default, no remote probe VLAN
is configured for a remote
destination group.
Assigning the monitor port to the remote probe VLAN
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter the interface view of
the monitor port.
interface interface-type interface-number N/A
3. Assign the port to the
probe VLAN.
• For an access port:
port access vlan vlan-id
• For a trunk port:
port trunk permit vlan vlan-id
• For a hybrid port:
port hybrid vlan vlan-id { tagged |
untagged }
For more information about the
port access vlan, port trunk
permit vlan, and port hybrid vlan
commands, see Layer 2—LAN
Switching Command Reference.
Configuring a remote source group on the source device
Creating a remote source group
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a remote source
group.
mirroring-group group-id remote-source
By default, no remote source
group exists on a device.
Configuring source ports for a remote source group
To configure source ports for a mirroring group, use one of the following methods:
• Assign a list of source ports to the mirroring group in system view.
• Assign a port to the mirroring group as a source port in interface view.
To assign multiple ports to a mirroring group as source ports in interface view, repeat the
operation.
When you configure source ports for a remote source group, follow these restrictions and guidelines:
• Do not assign a source port to the remote probe VLAN.
• A mirroring group can contain multiple source ports.
• A port can act as a source port for multiple mirroring groups.
• A source port cannot be configured as a reflector port, monitor port, or egress port.
Configuring source ports for a remote source group in system view