H3C Technologies H3C S6300 Series Switches - Manual (Page 181)

168
Configuring local port mirroring
A local mirroring group takes effect only when you configure the source ports and the monitor port for it.
Local port mirroring configuration task list
Tasks at a glance
1. (Required.) Creating a local mirroring group
2. (Required.) Configuring source ports for the local mirroring group
3. (Required.) Configuring the monitor port for the local mirroring group
Creating a local mirroring group
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a local mirroring
group.
mirroring-group group-id local
By default, no local mirroring
group exists.
Configuring source ports for the local mirroring group
To configure source ports for a local mirroring group, use one of the following methods:
• Assign a list of source ports to the mirroring group in system view.
• Assign a port to the mirroring group as a source port in interface view.
To assign multiple ports to the mirroring group as source ports in interface view, repeat the
operation.
Configuration restrictions and guidelines
When you configure source ports for a local mirroring group, follow these restrictions and guidelines:
• A mirroring group can contain multiple source ports.
• A port can act as a source port for multiple mirroring groups.
• A source port cannot be configured as a reflector port, egress port, or monitor port.
Configuring source ports in system view
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure source ports for the
specified local mirroring
group.
mirroring-group group-id
mirroring-port interface-list { both |
inbound | outbound }
By default, no source port is
configured for a local mirroring
group.
Configuring source ports in interface view