H3C Technologies H3C S6300 Series Switches - Manual (Page 89)

76
Field Description
Serial number
Serial number of the device that generated the log.
This field exists only in logs in unicom format that are sent to the log host.
Sysname (host name or
host IP address) The sysname is the host name or IP address of the device that generated the log.
You can use the sysname command to modify the name of the device.
%% (vendor ID)
Indicates that the information was generated by an H3C device.
This field exists only in logs sent to the log host.
vv (version information)
Identifies the version of the log, and has a value of 10.
This field exists only in logs that are sent to the log host.
Module
Specifies the name of the module that generated the log. You can enter the
info-center source ? command in system view to view the module list.
Level
Identifies the level of the log. See Table 6 for more information about severity
levels.
Mnemonic Describes the content of the log. It contains a string of up to 32 characters.
Source
Identifies the source of the log. It can take one of the following values:
• IRF member ID.
• IP address of the log sender.
Content Provides the content of the log.
Table 14 Timestamp precisions and configuration commands
Item Destined to the log host
Destined to the console, monitor
terminal, log buffer, and log file
Precision Seconds Milliseconds
Command used
to set the
timestamp
format
info-center timestamp loghost info-center timestamp
Table 15 Description of the timestamp parameters
Timestamp
parameters
Description Example
boot
Time that has elapsed since system startup, in
the format of xxx.yyy. xxx represents the
higher 32 bits, and yyy represents the lower
32 bits, of milliseconds elapsed.
Logs that are sent to all destinations other than
a log host support this parameter.
%0.109391473 Sysname
FTPD/5/FTPD_LOGIN: User ftp
(192.168.1.23) has logged in
successfully.
0.109391473 is a timestamp in the boot
format.
date
Current date and time, in the format of mmm
dd hh:mm:ss yyy for logs that are output to a
log host, or MMM DD hh:mm:ss:xxx YYYY for
logs that are output to other destinations.
All logs support this parameter.
%May 30 05:36:29:579 2003 Sysname
FTPD/5/FTPD_LOGIN: User ftp
(192.168.1.23) has logged in
successfully.
May 30 05:36:29:579 2003 is a
timestamp in the date format.