H3C Technologies H3C S6300 Series Switches - Manual (Page 187)

174
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the port as the
egress port for the specified
remote source group.
mirroring-group group-id
monitor-egress
By default, a port does not act as
the egress port for any remote
source group.
Configuring the remote probe VLAN for a remote source group
When you configure the remote probe VLAN for a remote source group, follow these restrictions and
guidelines:
• Only an existing static VLAN can be configured as a remote probe VLAN.
• When a VLAN is configured as a remote probe VLAN, use the remote probe VLAN for port
mirroring exclusively.
• The remote mirroring groups on the source device and destination device must use the same remote
probe VLAN.
To configure the remote probe VLAN for a remote source group:
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure the remote probe
VLAN for the specified remote
source group.
mirroring-group group-id
remote-probe vlan vlan-id
By default, no remote probe VLAN
is configured for a remote source
group.
Displaying and maintaining port mirroring
Execute display commands in any view.
Task Command
Display mirroring group information.
display mirroring-group { group-id | all | local |
remote-destination | remote-source }
Port mirroring configuration examples
Local port mirroring configuration example
Network requirements
As shown in Figure 58 , configure local port mirroring in source port mode so the server can monitor the
bidirectional traffic of the Marketing department and the Technical department.