H3C Technologies H3C S6300 Series Switches - Manual (Page 230)

217
c. On the Add Device Group page, enter a service group name (for example, DB_1), and then
click OK.
Figure 6 Adding a device group
d. Select Service > Resource > Device Class from the top navigation bar.
e. Click Add.
f. On the Add Device Class page, enter a device class name for devices in equipment room A,
and then click OK.
In this example, the device class for devices in equipment room A is Device_A.
Figure 7 Adding a device class
g. Repeat the previous two steps to create a device class for devices in equipment room B.
4. Add the devices as CPEs:
a. Select Service > BIMS > Add CPE from the top navigation bar.
b. On the Add CPE page, enter or select basic settings for device A, and then click OK.