Xerox WorkCentre 7835ii - Manual (Page 22)

Initial Setup
22 Xerox ® WorkCentre ® 7800/7800i Series Color Multifunction Printer
System Administrator Guide
Initial Setup at the Control Panel
Installation Wizard
The Installation wizard starts the first time you turn on the printer. The wizard prompts you with a series
of questions to help you configure basic printer settings.
Note: You can complete the wizard at any time.
• To assign a static IP address or change the default dynamic addressing settings, use the IP Address
Settings wizard.
• To add phone numbers for support or supplies contacts, use the Contact Numbers wizard.
• To configure basic embedded fax settings, use the Fax Setup wizard.
Using Installation Wizards
1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
2. Touch Device Settings > Additional Install Options.
3. To start a wizard, touch IP Address Settings, Contact Numbers, or Fax Setup.
4. Follow the onscreen instructions.
Setting the Measurement Units
1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
2. Touch Device Settings > General > Measurements.
3. To show dimensions in metric or imperial units, under Units, select an option.
4. To specify the decimal mark symbol that the printer uses, under Numeric Separator, select Comma
or Period.
5. Click OK.