Enabling fips 140 mode and checking for compliance – Xerox WorkCentre 7835ii User Manual
Page 97
Security
Xerox
®
WorkCentre
®
7800/7800i Series Color Multifunction Printer
97
System Administrator Guide
Enabling FIPS 140 Mode and Checking for Compliance
1.
In Xerox
®
CentreWare
®
Internet Services, click
Properties > Security > Encryption.
2.
Click FIPS 140-2.
3.
Click Enable.
4.
Click Run Configuration Check and Apply.
A pass or fail message appears:
−
If the configuration check passes, click Reboot Machine to save and restart the printer.
−
If the configuration check fails, the reasons for the failed test list in a table at the bottom of
the page. For each reason, a link is provided. Click the appropriate link to disable the protocol,
replace the certificate, or allow the printer to use the non-compliant protocol.
Note:
When FIPS 140 Mode is enabled, only FIPS-compliant certificates can be installed on the
printer.