To set the lan, Set the lan – RIGOL DM3068 User Manual
Page 113
Chapter 2 Front Panel Operations
RIGOL
User’s Guide for DM3068
2-71
To
Set the LAN
The LAN configuration parameters conform to LXI-C standards.
Before using this interface, connect the multimeter to the network using network
cable.
Fuse
AC 250V T250mA
AC 250V T125mA
~Line（25VA Max）
AC 100-120V 45-440Hz
AC 200-240V 45-66Hz
SEL
115
230
The LAN parameter configuration interface is as shown in the figure below.
1. LAN Status
Display the current network connection status (LAN Status).
Configured: indicate the LAN is connected.
Unlink: indicate the LAN is not connected.
Press Info and use the up and down direction keys to view other information of
network connection.
2. To Set IP Configuration Mode
The IP address configuration mode can be set to DHCP, AutoIP or ManualIP.
Different modes may have differences in parameter configuration.
LAN