RIGOL DM3068 - Manual (Page 127)

Chapter 3 Remote Control RIGOL
User’s Guide for DM3068 3-3
2) Press “Network Settings” to enter the interface as shown in the figure
below.
Set the IP via this interface, press “Apply” to enable the modification and
press “Cancel” to disable this setting. To restore to factory setting, press
“LAN Configuration Initialize”.
Explanation:
The password input box is displayed and the correct user name and
password are required when using the “Network Settings” function if the
multimeter has had a password set on it (the default user name and
password are empty).
3) Press “Web Control” to enter the instrument web page control interface.
At this point, you can configure the related parameters and acquire the
measurement result.