RIGOL DM3068 - Manual (Page 114)

RIGOL Chapter 2 Front Panel Operations
User’s Guide for DM3068 2-72
Tip
 When all three IP configuration modes are ON, the priority order of the
configuration mode is DHCP, AutoIP and ManualIP.
 At least one IP configuration mode should be ON.
1) DHCP
The DHCP server from the current network assigns network parameters
to the multimeter such as IP address.
Press DHCP to turn on or off the DHCP configuration mode.
2) AutoIP
The multimeter automatically acquires an IP address from 169.254.0.1 to
169.254.255.254 and a subnet mask 255.255.0.0 according to the
current network configurations.
Press AutoIP to turn on or off the AutoIP configuration mode. To enable
this mode, DHCP must be OFF.
3) ManualIP
Users define the network parameters such as IP address, subnet mask
and gateway.
Press Manual to turn on the ManualIP configuration mode and the
multimeter enters the following interface. To enable this mode, neither
DHCP nor AutoIP should be ON.
 IPAddr:
The format of IP address is nnn.nnn.nnn.nnn, for example
172.16.3.32. You are recommended to ask your network
administrator for an available IP address.
Press IPAddr and enter the desired IP address using the direction
keys.
 Mask: