RIGOL DM3068 - Manual (Page 130)

RIGOL Chapter 3 Remote Control
User’s Guide for DM3068 3-6
Remote Control via USB
1. Connect the Instrument
Connect the USB Device interface of DM3068 to the PC USB Host interface
using USB cable.
2. Install the USB Driver
DM3068 is a USBTMC device. After you connect the instrument to the PC and
turn both on (the instrument is automatically configured to USB interface), the
New Hardware Wizard is displayed on the PC. Please install the “USB Test
and Measurement Device” driver following the directions in the wizard.
3. Search USB Devices
Turn on the Ultra Sigma, the software automatically searches instruments
connected to the PC. Additionally, you can click to search the
resources. During the search, the status bar of the software is as shown in the
figure below.
4. View USB Device
The searched instruments are shown under the “RIGOL Online Resource”
directory with the model and USB interface information, as shown in the figure
below.