Rose Electronics QuadraVista HDMI - Manual (Page 99)

Installation and Operations Manual 95
To set up the QuadraVista HDMI with four computer systems, perform the
following steps by referencing the previous figure:
WARNING: DO NOT place any objects on the top or side panels of the
QuadraVista HDMI to avoid affecting its internal components heat
dissipation process.
1. Connect one end of the all-in-one cable to the SOURCE 1 connector
on the rear panel. Connect the other end to the first computer
system’s USB / PS-2 and audio ports by matching the colors of the
respective connectors.
2. Connect another all-in-one cable to the SOURCE 2 connector on the
rear panel and the other end to the second computer system’s USB /
PS-2 and audio ports.
3. Connect another all-in-one cable to the SOURCE 3 connector on the
rear panel and the other end to the third computer system’s USB /
PS-2, and audio ports.
4. Connect another all-in-one cable to the SOURCE 4 connector on the
rear panel and the other end to the fourth computer system’s USB /
PS-2, and audio ports.