Roland SP-404MKII Creative Sampler and Effector - Manual (Page 126)

Appendix
126
VERSION
Displays the version of this unit.
PAD SET
TRIGGER
Parameter Value Explanation
Curve
Type
Sets how the volume changes according to how hard you strike a pad.
Lin
This is the standard setting. This produces the most natural balance between playing dynamics and
volume change.
Exp Compared to “Lin”, playing strongly produces a greater change in volume.
Log Compared to “Lin”, playing softly produces a greater change in volume.
Fix Sets the volume at a fixed level of 127.
Threshold
1–
100
This sets the minimum sensitivity of the pads, at which the trigger signal is received only when a pad
is struck with at least a certain amount of force (velocity). This can be used to prevent a pad from
sounding due to vibrations from other pads.
Gain
0–
100
The sensitivity is adjusted with the curve as-is. The larger the value, the greater the sensitivity is when
playing the pads.
Trig Span
1–10 Adjusts the sensitivity of the pads to repeated strikes. With lower values, the pads detect repeated
strikes within a shorter time interval. Set this value higher if you don’t want the pad to accidentally
detect repeated strikes.
LED
Parameter Value Explanation
LED
Brightness
1–10 Sets the brightness of the indicators on the buttons and pads. This sets the brightness when the
buttons or pads are highlighted.
LED Glow
1–10 Sets the brightness of the indicators on the buttons and pads. This sets the brightness when the
buttons or pads are not highlighted.
Pad LED
Mode
This selects the color of the pad illumination.
BUS
The pads light up in the color set in “BUS COLOR”.
In this mode, the pad colors change according to the bus through which the sample audio is sent.
PAD The pads light up in the color set in “PAD COLOR”.
BUS COLOR