Roland SP-404MKII Creative Sampler and Effector - Manual (Page 64)

Combining Samples to Create a Pattern (PATTERN SEQUENCER)
64
11. When you are finished recording the pattern, press the [EXIT] button twice.
Press the [EXIT] button once to finish recording. The recorded pattern is automatically saved to the pad.
Press twice to stop pattern playback.
Functions you can use during TR-REC input
You can use the controllers in combination during TR-REC input to perform the following operations.
Controller Explanation
[DEL] button + [A/F] button
Deletes the notes (for one measure) corresponding to the selected
pad.
[DEL] button + [B/G] button Deletes the notes (for one measure) corresponding to all pads.
[ROLL] button + [CTRL 1] knob
You can record the motion of [CTRL 1] knob in the steps.
* This is enabled when MODE is “TRIG”.
[ROLL] button + [CTRL 2] knob
You can record the motion of [CTRL 2] knob in the steps.
* This is enabled when MODE is “TRIG”.
[ROLL] button + [CTRL 3] knob
You can record the motion of [CTRL 3] knob in the steps.
* This is enabled when MODE is “TRIG”.
[VALUE] knob (hold down) + [SUB PAD] button + pads [1]–
[16]
You can select samples without playing them back.
●
If you press the [RECORD SETTING] button while the pattern is recording, the RECORD SETTING screen is shown. Note that
you can’t set the LENGTH or TIME SIGN parameters at this time. These parameters need to be edited before you record the
pattern.
●
Press the [EXIT] button to return to the previous screen.
●
You can switch to pattern TR-REC by pressing the [REC] button while holding down the [SHIFT] button during pattern
playback.