Sampling the playback of a pattern chain – Roland SP-404MKII Creative Sampler and Effector User Manual
Page 69
Combining Samples to Create a Pattern (PATTERN SEQUENCER)
69
The unit enters pattern sequencer mode.
2.
While holding down the [HOLD] button, press pads [1]–[16] to select the pattern chain number to play
back.
The PATTERN CHAIN screen appears.
3.
Press the [SUB PAD] button.
The selected pattern chain plays back.
To stop playback, press the [SUB PAD] button again.
4.
To exit pattern chain, press the [EXIT] button.
The unit returns to the PATTERN SELECT screen.
Sampling the playback of a pattern chain
You can sample (resample) the audio of a pattern chain as it plays back.
1.
Press the [PATTERN SELECT] button.
The unit enters pattern sequencer mode.
2.
Press the [RESAMPLE] button.
3.
Press the [RECORD SETTING] button.
The input settings screen appears.
4.
Use the [CTRL 2] knob to set ROUTING to “Mix”.
5.
Press the [EXIT] button.
6.
Press the pads [1]–[16] that are blinking red.
Empty pads to which samples haven’t been assigned blink red.
When you press an empty pad, the pad changes to blinking purple, and a message “Press Pad to START” is shown.
7.
Press pads [1]–[16] while holding down the [HOLD] button to select the pattern chain to play back.
The PATTERN CHAIN screen appears.