Roland SP-404MKII Creative Sampler and Effector - Manual (Page 138)

Appendix
138
Equalizer
This is a three-band equalizer.
Parameter Value Explanation
LOW GAIN -15–15 (dB)
Adjusts the amount of boost/cut of the low-
frequency range.
MID GAIN -15–15 (dB)
Adjusts the amount of boost/cut of the
mid-frequency range.
HIGH GAIN -15–15 (dB)
Adjusts the amount of boost/cut of the
high-frequency range.
LOW FREQ 20, 25, 31, 40, 50, 63, 80, 100, 125, 160, 200, 250, 315, 400 (Hz) Sets the low-frequency range.
Mid Freq
200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500,
3150, 4000, 5000, 6300, 8000 (Hz)
Sets the mid-frequency range.
HIGH FREQ 2000, 2500, 3150, 4000, 5000, 6300, 8000, 10000, 12500, 16000
(Hz)
Sets the high-frequency range.
Compressor
This effect reduces high volume levels while bringing up the level of quieter sounds, smoothing out any variations in overall
volume.
Parameter Value Explanation
SUSTAIN 0–100 Sets how long the effect is applied to the decaying sound.
ATTACK 0–100 Sets how long it takes to reduce the volume when a high input level is detected.
RATIO 0–100 Sets the compression ratio.
LEVEL 0–100 Adjusts the volume of the effect sound.
This effect may output a very loud sound, depending on how the parameters are set. Use caution not to raise the values too
much.
SX Reverb
This adds reverberation to the sound.
As with the SP-404SX, you can adjust the volume balance between the dry (original) sound and the effect sound with this effect.
Parameter Value Explanation
TIME 0–100 Sets the reverb time.
TONE -12–+12 Adjusts the tonal character of the reverb.
BALANCE 100-0–0-100 (%) Adjusts the volume balance between the dry (original) sound and effect sound.
SX Delay
Gives an echo effect in sync with the tempo.
As with the SP-404SX, you can adjust the volume balance between the dry (original) sound and the effect sound with this effect.
Parameter Value Explanation
TIME
1/32, 1/16T, 1/32D, 1/16, 1/8T, 1/16D, 1/8, 1/4T, 1/8D,
1/4, 1/2T, 1/4D, 1/2, 1/1T, 1/2D, 1/1
Sets the sound delay time.
FEEDBACK 0–99 (%) Adjusts the amount of feedback for the effect.
BALANCE
100-0–0-100 (%) Adjusts the volume balance between the dry
(original) sound and effect sound.
Cloud Delay
Adds multiple delays to the dry sound, as well as reverberations for a thick “cloudy” effect.
Parameter Value Explanation
WINDOW
0–100 Adjusts the interval for the delayed sound.
Larger settings produce a deeper reverberation.