Roland SP-404MKII Creative Sampler and Effector - Manual (Page 147)

Appendix
147
Error Messages
Error messages Explanation Action
Battery Low!
The batteries are nearly depleted. Replace the batteries, or switch to an AC adaptor.
→ “ About the Power Supply (P.8)”
Unsupported
FILE
The file type is not supported on this unit. Check the file extension, format and folder directory.
→ “ Importing/Exporting (Using the SD Card) (P.114)”
No SD CARD!
No SD card is inserted. Also, the SD card
might not be fully inserted.
Turn off the power, and make sure that the SD card is fully
inserted before you turn the power back on.
Unsupported
SD Card!
An unsupported type of SD card has been
inserted.
Please format the SD card.
→ “ Formatting an SD Card (P.121)”
SD CARD
Protected!
The write-protect feature has been enabled
on the SD card.
Unlock the lock switch on the left side of the SD card.
SD CARD Full! The SD card has run out of free space. Delete any unneeded data on the card.
Internal Storage
Full!
There is not enough storage capacity left
on this unit.
Delete any unneeded data on the unit.
Storage Error!
A problem has occurred with the internal
storage.
Try performing a factory reset.
→ “ Restoring the Factory Settings (FACTORY RESET) (P.122)”
Protected!
The function can’t be executed because
bank protect is enabled.
Use a bank for which bank protect is disabled, or disable bank
protect on the currently selected bank.
→ “ Selecting a Sample Bank (P.12)” “ Selecting a Pattern
Bank (P.67)” “ Protecting a Sample (PROTECT) (P.57)” “ Protecting a
Pattern (PROTECT) (P.80)”
Max Length
Pattern
The maximum number of notes that can be
recorded to the pattern sequencer has
been exceeded.
Reduce the number of notes in the pattern, or shorten and split
the pattern to record.
→ “ Creating a New Pattern (Real-time Recording) (P.60)”
“ Creating a New Pattern (TR-REC) (P.62)”