Roland SP-404MKII Creative Sampler and Effector - Manual (Page 129)

Appendix
129
MFX List
Filter+Drive
This is a filter with overdrive.
It cuts the specified frequencies and adds distortion.
Parameter Value Explanation
CUTOFF 20–16000 (Hz) Sets the cutoff frequency range in which the filter works.
RESONANCE 0–100
Adjusts the filter’s resonance level.
The larger the value, the more that the frequency range set in CUTOFF is emphasized.
DRIVE 0–100 Adds distortion.
FLT TYPE
Sets the type of filter.
HPF Cuts off the low frequencies.
LPF Cuts off the high frequencies.
LOW FREQ 20–16000 (Hz) Adjusts the frequency range that’s boosted or cut by the LOW GAIN parameter.
LOW GAIN -24–24 (dB) Adjusts the amount of boost/cut applied to the frequency range that’s set in LOW FREQ.
Resonator
This effect uses “Karplus-Strong synthesis”, which is often used in physical modeling of sounds.
This lets you alter the sound with a maximum of six “resonators” that match different keys or chords.
Parameter Value Explanation
ROOT C1–G9 Sets the reference pitch (root note).
BRIGHT 0–100 Adjusts the tonal brightness.
FEEDBACK 0–99 (%) Adjusts the amount of feedback for the effect.
CHORD
Root, Oct, UpDn, P5, m3, m5, m7, m7oct, m0, m11,
M3, M5, M7, M7oct, M9, M11
Sets the composite notes (chord) to resonate.
PANNING 0–100 Sets the panning for the resonator.
ENV MOD 0–100
Larger values increase the amount of feedback
according to the input level.
Sync Delay
Gives an echo effect in sync with the tempo.
Parameter Value Explanation
TIME
1/32, 1/16T, 1/32D, 1/16, 1/8T, 1/16D, 1/8, 1/4T, 1/8D, 1/4,
1/2T, 1/4D, 1/2, 1/1T, 1/2D, 1/1
Sets the sound delay time.
FEEDBACK 0–99 (%) Adjusts the amount of feedback for the effect.
LEVEL 0–100 Adjusts the volume of the effect sound.
L DAMP F
FLAT, 80, 100, 125, 160, 200, 250, 315, 400, 500, 630, 800
(Hz)
Sets the frequency range that is attenuated each
time the delay repeats.
H DAMP F 630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000,
6300, 8000, 10000, 12500, FLAT (Hz)
Isolator
This effect lets you cut off sounds in a specified frequency range.
Parameter Value Explanation
LOW -INF, -41.87–+12 (dB) Adjusts the amount of boost/cut in the low-frequency range.
MID -INF, -41.87–+12 (dB) Adjusts the amount of boost/cut in the mid-frequency range.
HIGH -INF, -41.87–+12 (dB) Adjusts the amount of boost/cut in the high-frequency range.