Roland SP-404MKII Creative Sampler and Effector - Manual (Page 130)

Appendix
130
DJFX Looper
This effect loops the sound in short cycles.
You can vary the playback direction and playback speed of the input sound to get a turntable-type effect.
Parameter Value Explanation
LENGTH
0.230–0.012
(sec)
Sets the length of the loop.
SPEED
-100–100 Sets the playback direction and playback speed.
The loop plays backward when this is set to a negative value, stops when this is set to zero,
and plays forward when this is set to a positive value.
LOOP SW
OFF, ON Turn this ON while a sound is playing to make the sound play back in a loop, at a length
specified by the LENGTH parameter.
Turn this OFF to disable the loop.
Scatter
This effect swaps the sound played back by a loop in steps, altering its playback direction and gate length. This gives you the loop
playback a digital groove feeling.
Parameter Value Explanation
TYPE 1–10 Sets the scatter type.
DEPTH 10, 20, 30, 40, 50, 60, 70, 80, 90, 100 Adjusts the scatter depth.
SCATTER OFF, ON Switches the scatter effect on/off.
SPEED SINGLE, DOUBLE Sets the scatter speed.
Downer
Cyclically slows down the audio playback speed.
Parameter Value Explanation
DEPTH 0–100 Sets how much the playback speed should be slowed down.
RATE
1/32, 1/16, 1/8, 1/4,
1/2, 1, 2
Sets the period at which the playback speed is changed.
FILTER 0–100 Attenuates the high-frequency range.
PITCH
OFF, ON When this is turned ON, pitches that were lowered due to the change in speed are
converted to their original pitch.
RESONANCE 0–100
Adjusts the filter’s resonance level.
Increasing the value further emphasizes the effect, for a more unusual sound.
Ha-Dou
This effect generates a wave-like sound based on the input audio.
Parameter Value Explanation
MOD
DEPTH
0–100 Adjusts the depth of the effect sound.
TIME 0–100 Sets the length of the effect sound.
LEVEL 0–100 Adjusts the volume of the effect sound.
LOW CUT
FLAT, 20, 25, 31, 40, 50, 63, 80, 100, 125, 160, 200, 250, 315,
400, 500, 630, 800 (Hz)
Sets the frequency range at which the effect
sound is attenuated.
HIGH CUT
630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000,
6300, 8000, 10000, 12500, FLAT (Hz)
PRE DELAY 0–100 Sets the time it takes for the effect to sound.