FUJITSU TeamPoS 3000 XL - Manual (Page 100)

TeamPoS 3000 XL and XL
2
Installation
D900000145 Issue 3 5-54
3. Thread the cables through the stand beginning with the larger cables first. Two video
cables must be used; a DVI and a VGA. Two powered USB cables are required, one for
each arm of the stand. Audio cable and A-to-B USB cable (for MSR or keypad/MSR)
are optional. See cable configurations below. Thread the cables for the operator facing
display first followed by the cables for the customer facing display.
DVI Cable Configuration VGA Cable Configuration
with optional Audio Cable with optional Audio Cable
Audio DVI USB Audio VGA USB
4. For the operating facing display, thread the DVI (or VGA) cable through the bottom
cable channel as shown below, then bend 90° towards the outside of the bracket, then 90°
again towards the LCD mount. Thread the powered USB cable next followed by the
audio cable (optional), and A-to-B USB cable (optional).
5. For the customer facing display, thread the VGA (or DVI) cable through the top cable
channel as shown above, then bend 90° towards the outside of the bracket, then 90° again
towards the LCD mount. Thread the powered USB cable next followed by the audio
cable (optional), and A-to-B USB cable (optional).
Under the
Through the
Audio Cable
DVI
A-to-B Cable
VGA
Powered
Powered USB
DVI
A-to-B Cable
Audio Cable
Powered
Powered USB
VGA
Through the
Under the
DVI bends 90° toward outside before the
bridge then 90° again towards the LCD
VGA bends 90° toward outside before the
bridge then 90° again towards the LCD