FUJITSU TeamPoS 3000 XL - Manual (Page 47)

TeamPoS 3000 XL and XL
2
Installation
D900000145 Issue 3 5-1
CHAPTER 5 INSTALLATION
Caution: Confirm that the external power source is 100-240 VAC before
starting the operation. To prevent electric shock, confirm that the AC cable is
removed from the AC outlet anytime the panels are removed. Be sure to
observe all ESD precautions and power OFF procedures.
5.1 Panel Removal/Installation Process
In many cases, TeamPoS 3000 control units will be fully configured from the factory or at
configuration centers. Others will be configured during installation. This section shows how to
access the control unit components to add or change configurations and installation of Team PoS
3000 peripherals. Accessing the TeamPoS 3000 internal components always requires the
removal of the front panel.
5.1.1 Front Panel
Removing the front panel gives access to the motherboard, disk drives, CD/DVD drive and
optional partial battery backup.
Caution: Be sure to observe all ESD precautions and power off procedures.
1. To remove the front panel, use your assigned key to unlock the front door. Next open
front door by pulling forward from the notch.
.