FUJITSU TeamPoS 3000 XL - Manual (Page 186)

TeamPoS 3000 XL and XL
2
Maintenance
D900000145 Issue 3 7-53
7.11 Replacing the Power Supply
1. Remove the back panel (See Section 5.1.2).
2. Disconnect the power cable from the controller.
3. Remove the front panel (See Section 5.1.1). The yellow LED light should be off (See
Section 1.2).
4. Unseat the motherboard.
5. Remove the backplane assembly (See Section 7.8).
6. Unseat any installed I/O boards. It is not necessary to disconnect the cables, just remove
from the chassis to allow access to one of the mounting screws and the power supply
cables.
7. Remove the 3 mounting screws. Retain the screws.
Screw #1
Viewed from front of
Power Supply
Screw #1
From Rear
Screw #2
Viewed from rear of Power
Supply
Screw #3
Viewed from side of
Power Supply