FUJITSU TeamPoS 3000 XL User Manual
Page 140
TeamPoS 3000 XL and XL
2
Maintenance
D900000145
Issue 3
7-7
11. Push in slowly until motherboard assembly engages the lever.
12. Use the lever to fully seat the motherboard assembly.
13. Reinstall hard disk drives. Be sure to keep them in the same bay from which they were
removed.
14. Reinstall the front panel and reconnect the power cable (See Section 5.1.1).
15. Reinstall the back panel (See Section 5.1.2).
16. If this is an upgrade, install the upgrade label that comes with the upgrade kit to the side of
the unit near the serial number.
Note: The system CMOS must be set after replacing the motherboard. Be sure to execute the
BIOS Setup Operation on the BIOS setup screen. (For BIOS Setup Procedures please see
Chapter 9 for BIOS XL motherboards and Chapter 10 for BIOS XL
2
motherboards.)