FUJITSU TeamPoS 3000 XL - Manual (Page 184)

TeamPoS 3000 XL and XL
2
Maintenance
D900000145 Issue 3 7-51
7.10 Replacing PCI Add-In Card(s)
Caution: Be sure to observe all ESD precautions and power off procedures.
Viewing the back plane assembly from the rear, there is a vertical slot on the left side for the ½
height PCI card. The TP3K XL does not support full size PCI cards. The connector for the PCI
is located directly below this slot.
1. Remove the back panel (See Section 5.1.2).
2. Disconnect power cable from the controller.
3. Remove the front panel (See Section 5.1.1). The yellow LED light should be off (See Section
1.2).
4. Unseat the motherboard.
5. Remove the backplane assembly (See Section 7.8).
6. Remove old PCI card,