FUJITSU TeamPoS 3000 XL - Manual (Page 153)

TeamPoS 3000 XL and XL
2
Maintenance
7-20 Issue 3 D900000145
5. Remove old memory by pulling outward on the small metal latches at the side of the stick
as shown in the photo below. The memory stick will pop up and can be removed.
6. Insert upgraded memory (or additional memory) into the bottom socket first. (There is
only one way the memory stick will fit.) Angle the stick approximately 30° pressing to
the left to make sure the stick is properly seated. Then press down slightly on the edge of
the stick to make sure the memory is properly seated.
7. The release latch for the memory stick will snap into place when the stick is properly
seated.