FUJITSU TeamPoS 3000 XL - Manual (Page 137)

TeamPoS 3000 XL and XL
2
Maintenance
7-4 Issue 3 D900000145
7.2 Replacing the Motherboard
Caution: Be sure to observe all ESD precautions and power off procedures.
Before installing a new motherboard, ensure that the replacement motherboard jumpers have
been set correctly. (See Section 7.3.1 Motherboard Settings and Section 7.3.2, Picture of
Motherboard)
1. Remove the back panel (See Section 5.1.2).
2. Disconnect the power cable from the controller.
3. Remove the front panel (See Section 5.1.1). The yellow LED should be off (See Section
1.2).
4. Remove hard disk drive shield by pushing in on the right side and pulling off.
Note: Where more than one drive is used, notice which bay each disk drive is in. It is important
for correct reinstallation of the drives.