FUJITSU TeamPoS 3000 XL - Manual (Page 88)

TeamPoS 3000 XL and XL
2
Installation
D900000145 Issue 3 5-42
4. Thread the cables through the stand beginning with the larger cables first. Video cable
(either DVI or VGA) and powered USB are required. Audio cable and A-to-B USB
cable (for MSR or keypad/MSR) are optional. See cable configurations below.
DVI Cable Configuration
with optional Audio & A-to-B Cables
VGA Cable Configuration
with optional Audio & A-to-B Cables
DVI USB Audio pUSB VGA USB Audio pUSB
5. Use DVI or VGA, not both. Bend DVI (or VGA) 90° towards the outside of the bracket
(before the bridge) and then 90° again towards the LCD mount. Powered USB, audio
(optional), and A-to-B USB (optional) need to be threaded under the bridge.
6. Rotate the monitor stand as needed so that you can reach the cables as they are threaded
through the stand.
Audio Cable
(
ti l)
DVI Cable
Under the
bridge
A-to-B Cable
Under the
base
Through the
tunnel
VGA Cable
Powered USB
Under the
base
Under the
bridge
Through the
tunnel
Audio Cable
DVI Cable
A-to-B Cable
VGA
Powered USB