FUJITSU TeamPoS 3000 XL - Manual (Page 92)

TeamPoS 3000 XL and XL
2
Installation
D900000145 Issue 3 5-46
5.14.2 Single Dispersed LCD Stand
1. Remove only the hinge cap from the stand; leave the top and bottom hinge cover in place.
Some photos in this section show the bottom hinge cover and top hinge cover removed in
order to more clearly show the cable route; however, assembly is easier if the bottom
hinge cover and top hinge cover are left in place.
2. Remove the cover plate on the bottom of stand by removing the 4 M3x 05 flathead,
phillips 6mmcountersunk screws. Retain screws to reattach the cover plate after cables
have been routed.
Top Hinge
Cover
Lower Hinge
Cover
Hinge Cap