FUJITSU TeamPoS 3000 XL - Manual (Page 130)

TeamPoS 3000 XL and XL
2
General Operations
D900000145 Issue 3 6-1
Chapter 6 - General Operations
6.1 System Operations
This section contains general and periodic care and maintenance, and power ON
and OFF procedures for the TeamPoS terminals.
6.1.1 General Care and Maintenance
General cleaning of the terminal, peripherals, and MSR is required on a regular
basis. In particular, dust must be removed from external components, air vents,
fans, and exhaust screens to allow sufficient airflow to maintain proper internal
operating temperatures. Printers must also have paper dust and other foreign
matter removed regularly to maintain proper printer operation. The frequency of
this cleaning depends on installed environments. Lack of this cleaning will greatly
reduce equipment reliability.
To achieve the maximum reliability of the MSR, cleaning with an MSR cleaner
card must be performed approximately every 1,000 passes.
To keep the terminal and its peripherals in good working condition, follow the
guidelines in this section.
1. Wipe the terminal and peripherals with a clean, soft cloth, dampened with
water and mild soap. Never use abrasive pads or cleansers.
2. Handle the touchscreen with reasonable care when not integrated into a
monitor. Do not pull or stress the cables. Clean the touchscreen with
Isopropyl Alcohol 99% and lint free wipes. Always dampen the wipes and
then clean the touchscreen.
3. Vacuum the paper wells of the receipt and journal printers to remove paper
particles and dust.
4. Clean the MICR mechanism on the printer once a month or after every
6,000 checks.
Note: The procedures in this chapter are intended for store personnel. The
procedures in succeeding chapters are for authorized service personnel only.