FUJITSU TeamPoS 3000 XL - Manual (Page 134)

TeamPoS 3000 XL and XL
2
Maintenance
D900000145 Issue 3 7-1
Chapter 7 - Maintenance
Caution: Confirm that the external power source is 100-240 VAC before
starting the operation. To prevent electrical shock, confirm that the AC cable
is removed from the AC outlet anytime the covers are removed. Be sure to
observe all ESD precautions and power OFF procedures.
7.1 Periodic Maintenance
Only trained personnel must perform the following:
Vacuum all ventilation passageways on the control unit and peripherals. Ensure that these
passageways are open and free of dust and other debris that could restrict airflow.
Check the Power Supply Unit fan for proper operation annually. See BIOS settings for typical
fan speeds. If fan speed is approaching the low end, the fan should be replaced. Fan speeds can
be found under the hardware monitoring section of the BIOS. Replace lead acid batteries every
three years. If the model DT50III has the MICR option, check the function of, and clean the
MICR after every 6000 checks.
7.1.1 Power ON and OFF Sequence
This section presents the general procedures for powering ON and powering OFF the TeamPoS
3000 control unit. The instructions in this section assume that the terminal, operating system and
the application software have been installed. For any additional power-up procedures dictated by
the retail application, refer to the manuals provided with the application software.
Caution: With the exception of USB peripherals, never disconnect or
connect a peripheral while power is on its port. To avoid damage to the
control unit and peripherals, when connecting and disconnecting RS232
peripherals from the Boards, turn power OFF with the ports OFF switch (see
section 1.2), the TeamPoS 3000 power switch in the front of the unit or by
disconnecting AC power.