FUJITSU TeamPoS 3000 XL - Manual (Page 169)

TeamPoS 3000 XL and XL
2
Maintenance
7-36 Issue 3 D900000145
This second diagram shows a Backplane Assembly with the Combo Board and a blanking plate
installed beneath it. XL
2
Motherboard DOES NOT SUPPORT the COM Board but DOES
SUPPORT a single USB Board, or a single combo board.
Caution: Ports designated as Port C on the backplane (24V PUSB) and Port 3
on the Combo board (24V RS232) do not meet UL limited power source (LPS)
requirements. These ports are limited to only allowing 24V Retail POS RS232
or powered USB peripherals that do not exceed a rated current of 4 Amps.
Peripherals intended to be connected via - Jacketed Cable for external use rated
30 V, max 3.05m long, marked VW-1 or FT-1.
Note: When the Combo Board is installed, only one 24V port should be used for 24V
printer. Port 3 and Port C cannot provide 24V power to 2 printers simultaneously.