FUJITSU TeamPoS 3000 XL - Manual (Page 112)

TeamPoS 3000 XL and XL
2
Installation
D900000145 Issue 3 5-66
6. Insert connector cable into the connector in the Keypad/MSR. The cable only fits one
way and will snap into place.
7. Reattach rear cover of keypad/MSR. Align the top and outer edges first then ease the
tabs at the lower edge inside the shell until they snap into the notches.
8. For keypad/MSR installation only, snap the keycaps onto the keys.
9. Be sure the A-B USB cable is connected to the back of the LCD to power the
keypad/MSR. The MSR and MSR/Keypad have separate USB interfaces. AN A-BUSB
cable is required to connect to the controller.
Keycaps installed