FUJITSU TeamPoS 3000 XL User Manual
Page 139
TeamPoS 3000 XL and XL
2
Maintenance
7-6
Issue 3
D900000145
7. Pull the entire assembly out of the controller. Unscrew motherboard from chassis (2
screws) and disconnect the operating panel cable from the motherboard.
Note: Depending on your maintenance procedures, it may be necessary to remove the CPU, heat
sink, memory, CD drive and/or mini-PCI card from the old motherboard and reinstall on
the new motherboard. See appropriate sections of this chapter for removal and
replacement instructions.
8. Insert the replacement board onto the chassis and secure with 2 screws.
9. Reconnect the operating panel cable. Reinstall any other optional hardware. See note
above.
10. Make sure that the assembly rails line up with the rails in the chassis. Slide the
motherboard assembly in with the release lever at 45° angle.
2 screws
Disconnect operator
cable