Genicom cL160 - Manual (Page 196)

Publication No. GEG-99141 Genicom Apr 02
B-2 GENICOM Intelliprint cL160 User Guide
Safety Notes
About this Appendix
This appendix lists important safety precautions and identifies the applicable regulatory compli-
ances of your printer.
Safety Notes
• Be sure to switch off and unplug the printer before accessing the interior of the printer for
cleaning, maintenance, or fault clearance. Accessing the interior of a live machine exposes you
to the risk of electric shock.
• Do not place the printer in a hot, humid, dusty, or poorly ventilated environment. Prolonged
exposure to these adverse conditions may cause fire or expose you to electric shock.
• The printer is capable of operating normally within the following environmental limits:
• Temperature range: 50
°
F -95
°
F (10
°
C -35
°
C)
At high temperatures (95
°
F /35
°
C), humidity should be at or below 70%.
• Humidity range: 15%-85% (no condensation)
At maximum humidity (85%), temperature should be at or below 82
°
F(28
°
C).
• Stop operation immediately if your printer produces smoke, excessive heat, unusual noise, or
smell. These conditions can indicate or result in a fire. Immediately switch off and unplug the
printer, and contact your point of purchase.
• The fuser becomes very hot in normal operation. If a paper jam has occurred, turn the power
off and wait at least 10 minutes before removing the drum cartridge and touching the fuser
section.
Regulatory Compliance
Safety Compliance
This product conforms the following safety standards:
• UL1950
• CSA C22.2 No. 950
• EN 60950
• IEC 950
• 73/23/EEC
Class 1 Laser Device and CDRH Compliance
This printer is certified as a Class 1 laser product under the U.S. Department of Health and
Human Services (DHHS) Radiation Performance Standard according to the Radiation Control for
Health and Safety Act of 1968. This certification indicates that the printer does not emit hazardous
laser radiation. Since radiation emitted inside the printer is completely confined within the protec-
tive housings and external covers, the laser beam cannot escape from the machine during any phase
of user operation.
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administra-
tion implemented regulations for laser products on August 1976. These regulations apply to laser
products marketed in the United States. The label on the printer indicates compliance with the
CDRH regulations and must be attached to laser products marketed in the United States.