Solving printer power-on problems, Solving printer power-on problems 3-11 – Genicom cL160 User Manual
Page 93
Apr 02
Genicom
Publication No. GEG-99141
GENICOM Intelliprint cL160 User Guide
3-11
Solving Printer Power-on Problems
Solving Printer Power-on Problems
This section describes problems that can occur when starting up the printer. If the trouble persists
after performing the checks listed below, turn the printer off [ O ], disconnect the power cord from
the AC outlet, and see
”Appendix A General Information”
to arrange for a technical support or ser-
vice or repair call.
CAUTION: To prevent the risk of fire or smoke generation, do not attempt to modify the
printer in any way.
WARNING: Before cleaning the printer or performing any other maintenance, be sure to
turn the printer off [ O ], and disconnect the power cord from the AC outlet to prevent the
risk of electric shock.
DESCRIPTION
POSSIBLE
CAUSE
REQUIRED
ACTION
No power.
Power switch not turned
on. Switch is not set to
[ I ].
Check power switch. See
”Chapter 1 Unpacking and
Installing the Printer”
for
Printer” for more information
Power cord not properly
plugged into AC outlet or
AC connector on rear of
printer
Set power switch to [ O ] (off)
and plug in power cord firmly.
See
for more
information.
Voltage of AC power line
not correct.
Verify that AC outlet is rated for
the correct voltage and
amperage of your printer. See
”Chapter 1 Unpacking and
Installing the Printer”
for more
information.
Power is frequently
interrupted
Printer is defective
Turn printer off [ O ], disconnect
power cord from the AC outlet.
See
to arrange for a
technical support or service or
repair call.