Genicom cL160 - Manual (Page 44)

Publication No. GEG-99141 Genicom Apr 02
1-24 GENICOM Intelliprint cL160 User Guide
Turning the Printer On
1. Plug the power cord into the power inlet at the back of the printer. Plug the other end of the
cord into the AC outlet. Connect the earth connection to the ground, if possible.
Turning the Printer On
On the printer’s right side, press the side of the power switch marked [ I ] to turn the printer on.
NOTE: The printer motors run for 1 or 2 minutes when you first turn the power on.
The top line of the LCD display reads:
Loading
followed by asterisks progressing across the bottom line:
**************
Following a LED self test, asterisks progress across both lines of the display
**************
**************
and the Power On Self Test ends with the top line of the display reading:
Ready
NOTE: While turned on, the printer will go into the standby state if it remains idle for a period of time.If
an error message appears, see “Control Panel LCD Messages” in the Intelliprint cL160 User’s
Guide located on the
GENICOM Intelliprint CL160 Electronic Library .