About this appendix – Genicom cL160 User Manual
Page 210
Publication No. GEG-99141
Genicom
Apr 02
D-2
GENICOM Intelliprint cL160 User Guide
About this Appendix
This appendix lists some of the most frequently-used commands of the
Server command set.
More information about the command set, including additional options, can be found in the
Ethernet Network Interface Manual on the Electronic Library CD-ROM.
Please note the following before continuing:
•
In this command set appendix the NIC is referred to as the Server.
•
Commands are divided into Server (general), Port, and Protocol sections. Within each sec-
tion, commands are listed alphabetically.
•
Commands may require privileged user status. Enter
Set Privileged
, then enter the privi-
leged password when prompted.
•
When you enter a Define or Purge command, you must reboot the Server for the command
to take effect.
•
When the abbreviated syntax “
{EN|DIS}
” is shown, you must choose either Enabled or Dis-
abled to complete the command.
Each section lists additional information needed to use the command table in that section.